Mar 15, 2025 #nine I'm really confident 2k just indicates large Construct. The critical part is compatibility with bare metal. So what you want is actually a high Create direct to metallic (not acid etch) primer. This tends to fill in minor imperfections, and provide you with a sandable base. Despite the fact that it states metal, it is going to adhere just good to your paint. I'm recommending the excel because it will be just right for you over the bare and painted locations, and may preserve you from having to get multiple primers.
So to answer, then vent attaches to the top with the tank, and and obstruction could possibly be anyplace during the tube.
It'll count on your boat. I am in the course of doing work on mine at this time, I'll attach a pic afterward (Except if an individual beats me to it).
Warning: Don't place lots of tension using your fingers on the top (the place the brass screw threads are) and base on the ignition coil. You might snap the fragile Ferrite core inside of.
Jul 24, 2018 #9 Okay so I pulled the wires off and also the gauge didn't move. I pulled the gauge out, is there any method to bench check this factor? Perhaps the needle place is exactly where It is purported to be if it isn't obtaining any sign at all?
The first step is to try and do a Ohms examination to see If your coil is good right before happening into the visual inside ferrite Main inspection.
You may electronic mail the site owner to let them know you were blocked. Make sure you contain Whatever you ended up executing when this web site arrived up plus the Cloudflare Ray ID uncovered at The underside of the website page.
The diesel plus the dually are overkill, but I say go for the 4x4. It really is just excellent to possess in the pinch.
It would not be an issue should you let the epoxy dry, sanded, then applied urethane. It would be a problem while if the epoxy releases It truly is chemicles into the urethane mainly boat finder because it has not entirely cured.
At first i thought id bounce appropriate from your epoxy coat to my topcoat but i strategy on portray the bottom from the hull a shiny grey colour and the edges a blue. If i went topcoat soon after epoxy i figured I'd go earlier the recoat window on the next colour.
I will take the sender wire off the gauge, see if it goes down, then jumper the S terminal to your G terminal and see what takes place.
No, I don't head at all. By no means hurts to know something new or be reminded of anything I by now know
Mar fifteen, 2025 #7 If you do not need to clear, You will need for getting solitary phase paint. It'll deal with sanding scratches much better, be a little bit much more long lasting, but have much less UV defense and fewer forgiving to spray for your silver.
nine. If I tap on the gauge when it is actually both complete UP or DOWN, the gauge will shift from the route It is supposed to, but needs a large amount of tapping.